User & maintenance manual

Motorcycle trailer: user guide

How to load, strap, unstrap and unload a motorcycle on the tilting motorcycle trailer, and what to check before each trip.

At a glance

Ratchet straps
At least 4, 35 mm wide, 2 m long, plus 1 on the front wheel
First strap check
After the first 4 to 5 km
Following strap checks
At least every 2 hours of driving and after leaving the trailer unattended
Safety first
  • Use the trailer only to carry a motorcycle: any other use can damage it and cause injury or damage.
  • Unlock the tilt mechanism with the pedal on the right side of the chassis before reversing the motorcycle off: reversing without unlocking can damage the motorcycle and the trailer.
  • Before loosening a strap, keep a safety strap on that side so the motorcycle cannot fall to the other side.
  • Over-powerful ratchets can over-tighten the straps and damage the motorcycle or the trailer.
  • Replace any strap that is cut or frayed.
  • When reversing, do not jackknife the trailer: it can hit the towing vehicle.
  • Chock the wheels when coupling or uncoupling, especially on a slope.

Before you start

The platform does not tilt once the centre of gravity is passed
Ride the motorcycle back to its starting position and unlock the mechanism again.
Models with a tool box
Lock the tool box with its key before driving.
Motorcycle needs specific attachment points
Use the attachment points suited to your motorcycle and add straps if needed.

Check before every trip

  • Wheels correctly tightened
  • Spare wheel in place
  • Tool box and its support secure (and locked, if fitted)
  • Tilt lock/unlock mechanism working and friction parts oiled
  • Lights working
  • Tyre pressure correct
  • Straps in good condition (no cuts or fraying)

Maintenance

WhatWhen
Check the tilt lock/unlock mechanism and oil its friction partsBefore each use

Steps

0 / 6 done

  1. Open the number plate

    Open the number plate before loading.

  2. Ride onto the platform

    Ride the motorcycle onto the platform until the front wheel enters the wheel chock. The front wheel lock engages automatically.

  3. Strap the motorcycle

    Use at least 4 ratchet straps plus one on the front wheel. Front straps pull forwards; rear straps pull sideways and backwards.

  4. Check the straps on the road

    Check the strapping after the first 4 to 5 km, then at least every 2 hours and after leaving the trailer unattended.

  5. Unstrap safely

    Keep a safety strap on the side you loosen and release gradually until the side stand can be put down. Then remove all straps.

  6. Unlock the tilt and unload

    Open the number plate and unlock the tilt mechanism with the pedal on the right side of the chassis. Then reverse the motorcycle off.