Polyester bodywork care: polish, refinish and protect
Three-stage care of polyester (gelcoat) bodywork: polishing with NW 6, refinishing with Topfinish 2 and protecting with UV Shield wax.
![]()
All models
- Do not overheat the surface while polishing.
- Close the cap after use.
Before you start
- Dark shells (black, iron grey, burgundy, navy blue)
- Use the dark-shell renovation kit CZ001524.
- Light shells (white, light grey, natural green)
- Use the light-shell renovation kit CZ001525.
- Polishing pad choice (NW 6)
- Use the SL3 wool pad for a balanced cut, or the ST1 pad for a more aggressive cut.
- Finishing pad choice (Topfinish 2)
- Use the SL3 wool pad, or a medium-soft blue foam pad for a softer, cleaner finish.
- Protection with Easy Gloss
- The NW 6 and Topfinish 2 sheets show Easy Gloss with a soft foam pad as the protection step, instead of UV Shield.
At a glance
- NW 6 polisher speed
- 800-1,500 rpm
- Topfinish 2 polisher speed
- 1,000-2,000 rpm
- UV Shield drying time before removal
- 10-15 minutes or more
- Storage temperature
- 5-35 °C
Tools you need
- Variable-speed polisher
- SL3 wool pad
- ST1 pad
- Medium-soft blue foam pad
- S18 soft hand applicator
- Clean soft cloths
Steps
0 / 7 done
Polish with NW 6
Mix NW 6 well and apply a small quantity to the polisher pad. Start at low speed, then increase to 800-1,500 rpm, spreading with crossed movements.
Parts: NW 6 Rapid Cut
Wipe off
Repeat the application if necessary, without overheating the surface. Wipe off with a clean cloth.
Refinish with Topfinish 2
Shake Topfinish 2 and pour a small quantity onto the pad. Start at low speed, then increase to 1,000-2,000 rpm, spreading with crossed movements.
Parts: Topfinish 2
Wipe the surface
Repeat if necessary, without overheating the surface. Wipe the surface with a clean cloth.
Check the surface
Make sure the area is clean, with no oxidation or surface marks, before applying the wax.
Apply UV Shield
Shake, put a few drops on a small soft pad and spread evenly with firm circular movements. Go over the area several times.
Parts: UV Shield
Let dry and buff
Leave to dry for 10-15 minutes or more, then remove with a soft clean cloth.
Drawings
Maintenance
| What | When |
|---|---|
| Apply UV Shield protective wax | Once a season (the protection lasts about one season) |