Procedure

Polyester bodywork care: polish, refinish and protect

Three-stage care of polyester (gelcoat) bodywork: polishing with NW 6, refinishing with Topfinish 2 and protecting with UV Shield wax.

Cheval LibertéDebon TrailersAll models

Safety first
  • Do not overheat the surface while polishing.
  • Close the cap after use.

Before you start

Dark shells (black, iron grey, burgundy, navy blue)
Use the dark-shell renovation kit CZ001524.
Light shells (white, light grey, natural green)
Use the light-shell renovation kit CZ001525.
Polishing pad choice (NW 6)
Use the SL3 wool pad for a balanced cut, or the ST1 pad for a more aggressive cut.
Finishing pad choice (Topfinish 2)
Use the SL3 wool pad, or a medium-soft blue foam pad for a softer, cleaner finish.
Protection with Easy Gloss
The NW 6 and Topfinish 2 sheets show Easy Gloss with a soft foam pad as the protection step, instead of UV Shield.

At a glance

NW 6 polisher speed
800-1,500 rpm
Topfinish 2 polisher speed
1,000-2,000 rpm
UV Shield drying time before removal
10-15 minutes or more
Storage temperature
5-35 °C

Tools you need

  • Variable-speed polisher
  • SL3 wool pad
  • ST1 pad
  • Medium-soft blue foam pad
  • S18 soft hand applicator
  • Clean soft cloths

Steps

0 / 7 done

  1. Polish with NW 6

    Mix NW 6 well and apply a small quantity to the polisher pad. Start at low speed, then increase to 800-1,500 rpm, spreading with crossed movements.

    Parts: NW 6 Rapid Cut

  2. Wipe off

    Repeat the application if necessary, without overheating the surface. Wipe off with a clean cloth.

  3. Refinish with Topfinish 2

    Shake Topfinish 2 and pour a small quantity onto the pad. Start at low speed, then increase to 1,000-2,000 rpm, spreading with crossed movements.

    Parts: Topfinish 2

  4. Wipe the surface

    Repeat if necessary, without overheating the surface. Wipe the surface with a clean cloth.

  5. Check the surface

    Make sure the area is clean, with no oxidation or surface marks, before applying the wax.

  6. Apply UV Shield

    Shake, put a few drops on a small soft pad and spread evenly with firm circular movements. Go over the area several times.

    Parts: UV Shield

  7. Let dry and buff

    Leave to dry for 10-15 minutes or more, then remove with a soft clean cloth.

Drawings

Maintenance

WhatWhen
Apply UV Shield protective waxOnce a season (the protection lasts about one season)