Procedure

Replacing an axle shock absorber

How to remove the wheel and replace a trailer axle shock absorber, tightening its nuts to 60–80 Nm.

Cheval LibertéDebon TrailersAll models

The video loads from YouTube when you press play.
Fitting the shock absorber vertically (C255 example)
The video loads from YouTube when you press play.
Fitting the shock absorber horizontally (C255 example)
Safety first
  • Fit the axle shock absorber with its protective cover facing upwards.
  • Secure the trailer so it cannot roll, then raise it and secure it.

Before you start

Spare part CZ000002
Fits trailers with Pullman suspension, generation 1 and 2.

At a glance

Shock absorber nut torque
60–80 Nm

Tools you need

  • Torque wrench

Steps

0 / 10 done

  1. Secure the trailer

    Secure the trailer so it cannot roll.

  2. Loosen the wheel screws

    Loosen the wheel screws while the wheel is still on the ground.

  3. Raise the trailer

    Raise the trailer and secure it.

  4. Remove the wheel

    Unscrew the loosened wheel screws and take off the wheel.

  5. Unscrew the shock absorber

    Unscrew the screws (2) holding the shock absorber.

  6. Remove the old shock absorber

    Take off the worn shock absorber (1).

  7. Insert the screws

    Insert a screw (2) through each eye of the new shock absorber.

    Parts: Axle shock absorber

  8. Fit the plain nuts

    Screw a plain nut with its washer onto each screw and tighten to 60–80 Nm.

    Parts: Plain nuts with washers

  9. Fit to the brackets

    Pass the screws through the holes in the brackets on the trailer, cover facing upwards.

  10. Fit the self-locking nuts

    Screw on the self-locking nuts with their washers and tighten to 60–80 Nm.

    Parts: Self-locking nuts with washers

Drawings