Procedure
Replacing the wheel screws
How to replace the wheel screws on a braked drum or an unbraked hub, tighten them to 80 Nm and re-check them after a short drive.
![]()
All models
Safety first
- Secure the trailer so it cannot roll, and against falling once raised.
- Check the tightness of the wheel screws again after the first kilometres.
Before you start
- Braked or unbraked axle
- The procedure is the same for a brake drum and for an unbraked hub.
At a glance
- Wheel screw torque
- 80 Nm
- Re-check tightness
- After the first kilometres of driving
Tools you need
- Torque wrench
Steps
0 / 8 done
Secure the trailer
Secure the trailer so it cannot roll.
Loosen the wheel screws
Loosen the wheel screws (1) in the drum or hub.
Raise the trailer
Raise the trailer and secure it against falling.
Remove the screws
Unscrew and remove the worn screws.
Fit the new screws
Screw the new wheel screws into the drum or hub.
Parts: Wheel screws
Lower the trailer
Lower the trailer onto its wheels.
Tighten to 80 Nm
Tighten the wheel screws to 80 Nm with a torque wrench.
Re-check after a short drive
After driving the first kilometres, check that the screws are still tight.