Replacing the bearing nut in the brake drum
How to remove the wheel and hub cap, replace the brake drum bearing nut and tighten it to 280 Nm.
![]()
All models
- Raise the trailer and secure it so it cannot fall or roll.
- Unscrew the bearing nut by hand with a spanner. Never use a pneumatic (impact) wrench.
At a glance
- Bearing nut torque
- 280 Nm
Tools you need
- Hammer
- Spanner
- Torque wrench
- Mechanical grease
- Pipe with an inner diameter matching the hub cap
Steps
0 / 11 done
Loosen the wheel screws
Loosen the wheel screws while the wheel is still on the ground.
Raise the trailer
Raise the trailer and secure it so it cannot fall or roll.
Remove the wheel
Unscrew the loosened wheel screws and take off the wheel.
Remove the hub cap
Carefully tap the cap (1) of the bearing nut (2) off the drum (3) with a hammer.
Unscrew the bearing nut
Unscrew the bearing nut by hand with a spanner. Do not use a pneumatic wrench.
Grease the thread
Coat the axle stub thread with mechanical grease.
Fit the new bearing nut
Screw on the new bearing nut by hand with a spanner. Tighten it to 280 Nm with a torque wrench.
Parts: Bearing nut
Refit the hub cap
Drive the cap (1) back on with a pipe whose inner diameter matches the cap.
Refit the wheel
Put the wheel back on and screw in the wheel screws.
Lower the trailer
Lower the trailer onto its wheels.
Tighten the wheel screws
Tighten the wheel screws.