Procedure

Replacing a brake drum on the axle

How to remove the wheel and worn brake drum, fit a new drum with a new bearing nut tightened to 280 Nm, then adjust the brake.

Cheval LibertéDebon TrailersAll models

Safety first
  • Raise the trailer and secure it so it cannot fall or roll.
  • Unscrew the bearing nut by hand with a spanner. Never use a pneumatic (impact) wrench.
  • Pull the brake drum off by hand. Do not use a puller.

At a glance

Bearing nut torque
280 Nm
Adjusting screw back-off
About 1/4 turn after the shoes start to rub

Tools you need

  • Hammer
  • Spanner
  • Torque wrench
  • Mechanical grease

Steps

0 / 14 done

  1. Loosen the wheel screws

    Loosen the wheel screws while the wheel is still on the ground.

  2. Raise the trailer

    Raise the trailer and secure it so it cannot fall or roll.

  3. Remove the wheel

    Unscrew the loosened wheel screws and take off the wheel.

  4. Remove the hub cap

    Carefully tap the bearing nut cap off with a hammer.

  5. Unscrew the bearing nut

    Unscrew the bearing nut by hand with a spanner. Do not use a pneumatic wrench.

  6. Remove the drum

    Pull the worn brake drum off by hand, without a puller.

  7. Fit the new drum

    Fit the new brake drum on the axle stub.

    Parts: Brake drum

  8. Grease the thread

    Coat the axle stub thread with mechanical grease.

  9. Fit the new bearing nut

    Screw on the new bearing nut by hand with a spanner. Tighten it to 280 Nm with a torque wrench.

    Parts: Bearing nut

  10. Fit the new hub cap

    Fit a new bearing nut cap.

    Parts: Bearing nut cap

  11. Tighten the adjusting screw

    Turn the adjusting screw on the inner side of the drum until the shoes start to rub and the drum is hard to turn.

  12. Back off a quarter turn

    Loosen the screw by about a quarter of a turn. The drum must turn easily, with the shoes rubbing only lightly.

  13. Refit the wheel

    Put the wheel on the drum and screw in the wheel screws.

  14. Lower and tighten

    Lower the trailer onto its wheels and tighten the wheel screws.

Drawings