Procedure

Adjusting the trailer brakes

How to adjust the drum brake on each braked wheel with its adjusting screw, then check that the handbrake engages the brakes correctly.

Cheval LibertéDebon TrailersAll models

Safety first
  • Do not apply the handbrake while you adjust the brakes.
  • Raise the trailer and secure it so it cannot fall or roll.

Before you start

GF-type handbrake: brake rod (2) still slack after adjustment
Tighten the ball nut (3) on the rod, then lock it with the counter nut (4).

At a glance

Adjusting screw back-off
About 1/4 turn after the shoes start to rub
Handbrake check
Brakes engage with the lever pulled to the 2nd notch

Steps

0 / 9 done

  1. Release the handbrake

    Make sure the handbrake is released. It must stay released during the whole adjustment.

  2. Raise the trailer

    Raise the trailer and secure it so it cannot fall or roll.

  3. Find the adjusting screw

    Each brake is adjusted with the screw (1) on the brake back plate.

  4. Tighten the adjusting screw

    Turn the screw (1) until the brake shoes start to rub and the drum is hard to turn.

  5. Back off a quarter turn

    Loosen the screw by about a quarter of a turn. The drum must turn easily, with the shoes rubbing only lightly.

  6. Repeat on every braked wheel

    Carry out the same adjustment on all the braked wheels of the trailer.

  7. Check the handbrake

    Pull the handbrake lever to the second notch. The trailer brakes should engage.

  8. Tension the brake rod (GF handbrake)

    If the brake rod (2) is slack, tighten the ball nut (3) on the rod and lock it with the counter nut (4).

    Parts: Ball nut, counter nut

  9. Lower the trailer

    Lower the trailer back onto its wheels.

Drawings