Adjusting the brakes and replacing the tandem equaliser bar
How to fit the brake equaliser bar on a twin-axle trailer, adjust the drum brakes on every braked wheel and check the handbrake.
![]()
All models
- Do not apply the handbrake while you adjust the brakes.
- Raise the trailer and secure it so it cannot fall or roll.
Before you start
- HF-type handbrake
- With correct adjustment, the brakes engage when the lever is pulled to the second notch.
- GF-type handbrake: equaliser bars and brake rod still slack after adjustment
- Tighten the M10 ball nuts on the rod and lock them with the M10 counter nuts.
At a glance
- Adjusting screw back-off
- About 1/4 turn after the shoes start to rub
- Handbrake check
- Brakes engage with the lever pulled to the 2nd notch
- Brake rod nuts (GF handbrake)
- M10 ball nuts and M10 counter nuts
Steps
0 / 10 done
Release the handbrake
Make sure the handbrake is released. It must stay released during the whole adjustment.
Raise the trailer
Raise the trailer and secure it so it cannot fall or roll.
Fit the equaliser bar
Fit the tandem equaliser bar assembly as shown in photo 1.
Parts: Tandem equaliser bar assembly
Find the adjusting screw
Each brake is adjusted with the screw (1) on the brake back plate.
Tighten the adjusting screw
Turn the screw (1) until the brake shoes start to rub and the drum is hard to turn.
Back off a quarter turn
Loosen the screw by about a quarter of a turn. The drum must turn easily, with the shoes rubbing only lightly.
Repeat on every braked wheel
Carry out the same adjustment on all the braked wheels of the trailer.
Check the handbrake (HF type)
Pull the handbrake lever to the second notch. The trailer brakes should engage.
Tension the linkage (GF type)
If the equaliser bars and brake rod are slack, tighten the M10 ball nuts on the rod and lock them with the M10 counter nuts.
Parts: M10 ball nuts, M10 counter nuts
Lower the trailer
Lower the trailer back onto its wheels.