Procedure
Adjusting the hydraulic power unit
Three steps to reset the adjusting screw of the hydraulic power unit on Debon PW tippers with a 6 mm Allen key and a 17 mm wrench.
PW tippers
At a glance
- Final setting
- Allen bolt screwed fully in, then unscrewed 4.25 turns
Tools you need
- 17 mm wrench
- 6 mm Allen key
Steps
0 / 3 done
Loosen the locking nut
Put the 6 mm Allen key in the adjusting screw on the power unit. Unscrew its locking nut as far as possible with the 17 mm wrench.
Screw the bolt fully in
Tighten the Allen bolt until it reaches the end of the thread.
Set and lock
Unscrew the Allen bolt 4.25 turns. Hold it there and tighten the locking nut with the 17 mm wrench.