Procedure

Replacing and maintaining the ball coupling

How to read the wear indicator, replace a worn KNOTT ball coupling on the drawbar with the correct bolt torques, and keep it in good working order.

Cheval LibertéDebon TrailersAll models

Safety first
  • If the wear indicator on the ball coupling is in the "-" zone, a coupling part is worn: replace the ball coupling.
  • Secure the trailer so that it cannot move before starting.
  • Always fit the new ball coupling with new self-locking bolts and nuts.

Before you start

M12 bolts, grade 8.8
Tighten the nuts to 77 Nm.
M12 bolts, grade 10.9
Tighten the nuts to 115 Nm.
M14 bolts, grade 10.9
Tighten the nuts to 125 Nm.

At a glance

Torque, M12 bolt grade 8.8
77 Nm
Torque, M12 bolt grade 10.9
115 Nm
Torque, M14 bolt grade 10.9
125 Nm
Pin to drive out the rear bolt
10 mm diameter

Tools you need

  • 10 mm diameter pin, as long as the drawbar slide is wide
  • Torque wrench
  • Grease

Steps

0 / 11 done

  1. Check the wear indicator

    Look at the wear indicator (2) on the ball coupling (1). If it is in the "-" zone, the ball coupling must be replaced.

  2. Secure the trailer

    Secure the trailer so that it cannot move.

  3. Pull back the bellows

    Pull the rubber bellows (8) back off the rear securing bolt (3).

  4. Remove the rear bolt

    Undo the nut (4) of the rear bolt (3) and drive the bolt out with a 10 mm pin. Leave the pin in the drawbar slide and in the shock absorber eye.

  5. Remove the old ball coupling

    Undo the nut of the front securing bolt, drive out the front bolt (5) and lift off the ball coupling.

  6. Clean the drawbar slide

    Thoroughly clean the drawbar slide on which the ball coupling sits.

  7. Fit the new ball coupling

    Place the new ball coupling on the drawbar slide.

    Parts: Ball coupling

  8. Insert the new bolts

    Insert the new securing bolts. As you push in the rear bolt (3), it drives the pin out of the shock absorber eye.

    Parts: New securing bolts

  9. Fit washer and nuts

    Place a new levelling washer (7) on the rear bolt (3), then fit new self-locking nuts.

    Parts: Levelling washer, self-locking nuts

  10. Tighten to torque

    Tighten with a torque wrench: 77 Nm for M12 8.8, 115 Nm for M12 10.9, 125 Nm for M14 10.9 bolts.

  11. Refit the bellows

    Pull the rubber bellows (8) back over the rear bolt (3) so that its moulded projection covers the bolt.

    Parts: Rubber bellows

Drawings

Maintenance

WhatWhen
Clean and grease all moving parts of the coupling, especially the ball seatRegularly, depending on how intensively the trailer is used
Check the position of the wear indicatorRegularly