Procedure

Replacing the overrun coupling shock absorber

How to remove the ball coupling and replace the gas-filled shock absorber of a KNOTT overrun coupling, with the bolt tightening torques.

Cheval LibertéDebon TrailersAll models

Safety first
  • The coupling shock absorber contains gas under high pressure: take particular care when removing it.
  • Secure the trailer so that it cannot move before starting.
  • Use new self-locking nuts when refitting the ball coupling.

Before you start

Depending on the coupling type
The shock absorber bracket is held by one or two screws (6): remove and refit all of them.
If a locking pin is fitted in the drawbar slide
Remove it before sliding out the old shock absorber and refit it after inserting the new one.

At a glance

Torque, M12 bolt grade 8.8
77 Nm
Torque, M12 bolt grade 10.9
115 Nm
Torque, M14 bolt grade 10.9
125 Nm
Shock absorber type
Shown on the trailer data plate

Tools you need

  • Torque wrench

Steps

0 / 17 done

  1. Secure the trailer

    Secure the trailer so that it cannot move.

  2. Remove the overrun coupling

    Remove the overrun coupling from the trailer.

  3. Pull back the bellows

    Pull the rubber bellows (1) back off the rear bolt (3) that holds the ball coupling.

  4. Remove the rear bolt

    Undo the nut (2) of the rear bolt, remove the levelling washer (7) and take out the bolt.

  5. Remove the ball coupling

    Undo the second bolt and lift off the ball coupling.

  6. Undo the outer nut

    At the rear of the coupling, undo the outer nut (4) on the shock absorber piston rod.

  7. Remove the bracket

    Undo the screw(s) (6) holding the shock absorber bracket to the coupling housing and pull out the bracket (5).

  8. Undo the inner nut

    Undo the inner nut on the shock absorber piston rod.

  9. Remove the locking pin

    If fitted, remove the pin that locks the shock absorber in the drawbar slide, on the shock absorber eye side.

  10. Slide out the old shock absorber

    Slide the shock absorber out from the ball coupling end (front of the coupling).

  11. Insert the new shock absorber

    Place the new shock absorber in the drawbar slide and refit the locking pin if there is one.

    Parts: Coupling shock absorber, locking pin (if fitted)

  12. Refit the ball coupling

    Fit the ball coupling on the slide and insert its bolts (3), making sure the rear bolt passes through the shock absorber head.

    Parts: Ball coupling bolts

  13. Tighten to torque

    Fit the levelling washer (7) and a new self-locking nut. Tighten to 77 Nm (M12 8.8), 115 Nm (M12 10.9) or 125 Nm (M14 10.9).

    Parts: Levelling washer, self-locking nuts

  14. Refit the bellows

    Pull the rubber bellows (1) back over the rear bolt (3).

    Parts: Rubber bellows

  15. Refit the bracket on the piston rod

    Tighten the inner nut on the piston rod, place the bracket on the rod, add the spring washer and tighten the outer nut (4).

    Parts: Spring washer

  16. Fix the bracket to the housing

    Push in the piston rod and screw the bracket to the housing with the screw(s) (6) and spring washer.

  17. Refit the overrun coupling

    Mount the overrun coupling back on the trailer.

Drawings