Replacing the overrun coupling shock absorber
How to remove the ball coupling and replace the gas-filled shock absorber of a KNOTT overrun coupling, with the bolt tightening torques.
![]()
All models
- The coupling shock absorber contains gas under high pressure: take particular care when removing it.
- Secure the trailer so that it cannot move before starting.
- Use new self-locking nuts when refitting the ball coupling.
Before you start
- Depending on the coupling type
- The shock absorber bracket is held by one or two screws (6): remove and refit all of them.
- If a locking pin is fitted in the drawbar slide
- Remove it before sliding out the old shock absorber and refit it after inserting the new one.
At a glance
- Torque, M12 bolt grade 8.8
- 77 Nm
- Torque, M12 bolt grade 10.9
- 115 Nm
- Torque, M14 bolt grade 10.9
- 125 Nm
- Shock absorber type
- Shown on the trailer data plate
Tools you need
- Torque wrench
Steps
0 / 17 done
Secure the trailer
Secure the trailer so that it cannot move.
Remove the overrun coupling
Remove the overrun coupling from the trailer.
Pull back the bellows
Pull the rubber bellows (1) back off the rear bolt (3) that holds the ball coupling.
Remove the rear bolt
Undo the nut (2) of the rear bolt, remove the levelling washer (7) and take out the bolt.
Remove the ball coupling
Undo the second bolt and lift off the ball coupling.
Undo the outer nut
At the rear of the coupling, undo the outer nut (4) on the shock absorber piston rod.
Remove the bracket
Undo the screw(s) (6) holding the shock absorber bracket to the coupling housing and pull out the bracket (5).
Undo the inner nut
Undo the inner nut on the shock absorber piston rod.
Remove the locking pin
If fitted, remove the pin that locks the shock absorber in the drawbar slide, on the shock absorber eye side.
Slide out the old shock absorber
Slide the shock absorber out from the ball coupling end (front of the coupling).
Insert the new shock absorber
Place the new shock absorber in the drawbar slide and refit the locking pin if there is one.
Parts: Coupling shock absorber, locking pin (if fitted)
Refit the ball coupling
Fit the ball coupling on the slide and insert its bolts (3), making sure the rear bolt passes through the shock absorber head.
Parts: Ball coupling bolts
Tighten to torque
Fit the levelling washer (7) and a new self-locking nut. Tighten to 77 Nm (M12 8.8), 115 Nm (M12 10.9) or 125 Nm (M14 10.9).
Parts: Levelling washer, self-locking nuts
Refit the bellows
Pull the rubber bellows (1) back over the rear bolt (3).
Parts: Rubber bellows
Refit the bracket on the piston rod
Tighten the inner nut on the piston rod, place the bracket on the rod, add the spring washer and tighten the outer nut (4).
Parts: Spring washer
Fix the bracket to the housing
Push in the piston rod and screw the bracket to the housing with the screw(s) (6) and spring washer.
Refit the overrun coupling
Mount the overrun coupling back on the trailer.