Replacing an axle shock absorber
How to remove the wheel and replace a trailer axle shock absorber, tightening its nuts to 60–80 Nm.
![]()
All models
- Fit the axle shock absorber with its protective cover facing upwards.
- Secure the trailer so it cannot roll, then raise it and secure it.
Before you start
- Spare part CZ000002
- Fits trailers with Pullman suspension, generation 1 and 2.
At a glance
- Shock absorber nut torque
- 60–80 Nm
Tools you need
- Torque wrench
Steps
0 / 10 done
Secure the trailer
Secure the trailer so it cannot roll.
Loosen the wheel screws
Loosen the wheel screws while the wheel is still on the ground.
Raise the trailer
Raise the trailer and secure it.
Remove the wheel
Unscrew the loosened wheel screws and take off the wheel.
Unscrew the shock absorber
Unscrew the screws (2) holding the shock absorber.
Remove the old shock absorber
Take off the worn shock absorber (1).
Insert the screws
Insert a screw (2) through each eye of the new shock absorber.
Parts: Axle shock absorber
Fit the plain nuts
Screw a plain nut with its washer onto each screw and tighten to 60–80 Nm.
Parts: Plain nuts with washers
Fit to the brackets
Pass the screws through the holes in the brackets on the trailer, cover facing upwards.
Fit the self-locking nuts
Screw on the self-locking nuts with their washers and tighten to 60–80 Nm.
Parts: Self-locking nuts with washers