Adjusting the trailer brakes
How to adjust the drum brake on each braked wheel with its adjusting screw, then check that the handbrake engages the brakes correctly.
![]()
All models
- Do not apply the handbrake while you adjust the brakes.
- Raise the trailer and secure it so it cannot fall or roll.
Before you start
- GF-type handbrake: brake rod (2) still slack after adjustment
- Tighten the ball nut (3) on the rod, then lock it with the counter nut (4).
At a glance
- Adjusting screw back-off
- About 1/4 turn after the shoes start to rub
- Handbrake check
- Brakes engage with the lever pulled to the 2nd notch
Steps
0 / 9 done
Release the handbrake
Make sure the handbrake is released. It must stay released during the whole adjustment.
Raise the trailer
Raise the trailer and secure it so it cannot fall or roll.
Find the adjusting screw
Each brake is adjusted with the screw (1) on the brake back plate.
Tighten the adjusting screw
Turn the screw (1) until the brake shoes start to rub and the drum is hard to turn.
Back off a quarter turn
Loosen the screw by about a quarter of a turn. The drum must turn easily, with the shoes rubbing only lightly.
Repeat on every braked wheel
Carry out the same adjustment on all the braked wheels of the trailer.
Check the handbrake
Pull the handbrake lever to the second notch. The trailer brakes should engage.
Tension the brake rod (GF handbrake)
If the brake rod (2) is slack, tighten the ball nut (3) on the rod and lock it with the counter nut (4).
Parts: Ball nut, counter nut
Lower the trailer
Lower the trailer back onto its wheels.