Procedure

Replacing the brake cables

How to remove worn brake cables, fit new ones between the equaliser bar and the brakes, then readjust the trailer brakes.

Cheval LibertéDebon TrailersAll models

Safety first
  • Secure the trailer so it cannot roll before changing the cables.
  • Do not apply the handbrake while you adjust the brakes.
  • Raise the trailer so the wheels can turn, and secure it against falling and rolling.

Before you start

Single-axle trailer, or front axle of a twin-axle trailer
Use brake cable 1,230/1,440 mm (CZ001178).
Rear axle of a twin-axle trailer
Use brake cable 1,630/1,840 mm (CZ001179).
PW1.2 tipper
Use brake cable 730/920 mm (CZ002071).

At a glance

Adjusting screw back-off
About 1/4 turn after the shoes start to rub
Handbrake check
Brakes engage with the lever pulled to the 2nd notch

Steps

0 / 18 done

  1. Secure the trailer

    Secure the trailer so it cannot roll.

  2. Unclip the cable sheath

    Unclip the cable sheath from the cable bracket.

  3. Remove the sheath end

    Pull the sheath end fitting (1) off the cable cover cup.

  4. Remove the cover cup

    Remove the cable cover cup.

  5. Unhook the cable at the brake

    Slide the cable out of the eye (2) at the brake.

  6. Loosen the equaliser nuts

    At the equaliser bar, unscrew the self-locking nut and the ball nut.

  7. Remove the old cable

    Take the cable out of the equaliser bar.

  8. Fit the new cable to the equaliser

    Insert the new cable into the equaliser bar.

    Parts: Brake cable

  9. Tighten the equaliser nuts

    Tighten the ball nut and the self-locking nut.

  10. Hook the cable at the brake

    Slide the cable into the eye (2) of the expander at the brake.

  11. Refit the cover cup

    Fit the cable cover cup back on.

  12. Refit the sheath end

    Fit the sheath end fitting (1) onto the cover cup.

  13. Clip the sheath in place

    Clip the cable sheath back into its bracket.

  14. Raise the trailer

    With the handbrake released, raise the trailer so the wheels can turn. Secure it against falling and rolling.

  15. Tighten the adjusting screw

    Turn the adjusting screw on the brake back plate until the shoes start to rub and the wheel is hard to turn.

  16. Back off a quarter turn

    Loosen the screw by about a quarter of a turn so the wheel turns easily.

  17. Check the handbrake

    Pull the handbrake lever to the second notch. The trailer brakes should engage.

  18. Tension the brake rod

    If the brake rod is slack, tighten the ball nut on the rod and lock it with the counter nut.

Drawings